VWEIRAUCH-PARTS

BDA - manuals "Scanner"

Dear customer,

Thank you for the scanner (the KR 9 channel run light).

Your run light has gone through a thorough testing and final inspection, so we

hope that it meets your expectations and prepares you to enjoy!

It is however recommended to carefully read the entire document to any errors to

avoid.

Operation

1.1 The speed setting

The users are 255 speed levels available, which allow"UP +"""

and""Down""Keys set.

This causes the pressing"" UP ""- One key speed, the

Press the"" Down""-Key a reduction in this.

As soon as the maximum speed by pressing the "" UP"- button reached"

will, be aware that first led alive at the subsequent press

as a sign to achieve the maximum rate. The same applies for

the "" down"- button." The minimum speed is reached after 255 steps to

is signaled them with void sixteenth LED the.

The next level of speed is from the controller immediately when you click the button

registered. Only takes over after processing the current activity

(Move from one to the other led). This cause delays when the

Speed shift from slow to faster speeds. These

Delays are getting shorter with increasing speed.

1.2 Program selection

The programmes are by pressing the"" PROG ""-Button changed.

While the key must remain so long down, until only one led alive.

The corresponding led display program changes. To switch from the

Fourth program in the fifth to only the alive when the fifth led and signals

Thus, the following program is the fifth.

Does the fifteenth program which the previous fourteen programs

run one at a time can be, said shall expire the 8 and 9 led than characters

to reach the last programme.

The controller is programmed awaiting the end of the program

and only then does the next program.

The move to the next program period is dependent on the currently selected

Program and set speed.

1.3. Save favorite program

When you first start the engine and after every reboot the first which runs

fastest speed. Can this setting you change in how

describe their favorite program with its speed set and then

again the "Press"PROG"- button" until the next program led alive.

This condition has been reached, the need to store "pressed"UP"button and"

then both keys must be released at the same time.

The controller loads the saved values after the successful back and goes with the

secure program continues.

Press never all buttons or any other combination, this could lead to the deletion or destruction of the KR controller.

Information

The KR offers 9 programs that endlessly through their setting.

!!!! CAUTION! -the voltage regulator can be hot when higher tension!

! CAUTION!- the resistance can be hot!

!CAUTION!- the MOSFET's hot to!

Operate KR only in the specified range of voltage.

A higher voltage can lead to the destruction of the device.

Processor reverse polarity connection of voltage can lead to the destruction of the device.

! IMPORTANT!- operation must a sufficiently dimensioned DC power supply

be used.

Contact

For questions, comments and suggestions you can us under the following

Contact email: vweirauch@aol.com



Technical data

Controller: Atmega8 8L

Speed: 255 levels

Programs: 9

Voltage: 12V